Removing Hard to Remove Poppets

Hard to Remove Keg Poppets?

Some poppets seem to be almost installed permanently in keg posts. I think this is by design and that the reason they seem to be is because they… are. I don’t like those because they’re more difficult, potentially impossible, to clean and sanitize.

When I run into poppets like this I use a punch to dislodge the old poppet.  It usually doesn’t take a whole lot of force.

It’s noting that it’s possible that you could damage the poppet doing this. To me, that doesn’t matter a whole bunch to me since I’m going to replace them with Universal Poppets.

Also Consider: Universal Poppets – 304 Stainless + Food Grade Silicone! & Reliable O-Ring Replacements

universal poppetsValuebrew has released a 304 Stainless Steel + Food Grade Silicone Universal Poppet option!

I’ve long advocated for tossing OEM o-rings. I’m excited that there’s finally there’s an option that comes with quality o-rings made from the right materials out of the box! Beyond that, Valuebrew has pledged to always carry replacement o-rings, so you’ll always have a source when the time comes for replacements.

This write-up is part of my post on rebuilding kegsJump To This Section – If you look through the post you’ll see just how good the keg looks at the end.

More Homebrew Finds!

Let’s Be Friends!

Subscribe To Our Email!8 Ways to Connect with HBF

Quick Catch-Ups

Top Content

This post may contain affiliate links. We may make a commission when you use our links. This will never cost you extra. Thank you for supporting Homebrew Finds!

Make sure the components you use are compatible and rated for your intended application.  Contact manufacturer with questions about suitability or a specific application.  Always read and follow manufacturer directions. top:rebuildkeglnksto lnksto:kegrebuild rp:lnksdiffpoppets

Leave a Reply