Get a Used Keg?… Replace Keg O-Rings

Replacing Keg O-Rings

When you get a used keg, in my opinion, you’re going to want to replace all the o-rings in your keg.  Generally speaking they are going to be worn out and even if they aren’t they’ll smell of soda pre-mix.  Beyond that, who knows what they’re made from.  Start with a clean slate.  As you saw earlier, the o-rings in this keg were a grubby mismatch of soda drenched o-rings.

Most of these o-rings are pennies each when bought in reasonable bulk quantities. It’s worth the small cost to start fresh with o-rings made from appropriate materials.

This write-up is part of my post on rebuilding kegsJump To This Section – If you look through the post you’ll see just how good the keg looks at the end.

More Homebrew Finds!

Let’s Be Friends!

Subscribe To Our Email!8 Ways to Connect with HBF

Quick Catch-Ups

Top Content

More: Our Last Fifty Finds!


Make sure the components you use are compatible and rated for your intended application.  Contact manufacturer with questions about suitability or a specific application.  Always read and follow manufacturer directions. top:rebuildkeglnksto lnksto:kegrebuild rp:lnksreplacorings

Leave a Reply