(100) 013 Silicone O-Ring, 70A Durometer, Red, 7/16″ ID, 9/16″ OD, 1/16″ Width

Dash 013 o-rings are not OEM internal ball lock QD gaskets, but in my experience they have fit in all the QDs that I’ve tried.  Your experience may vary.  Check out my post on the subject including some photos – See: CMBecker Ball Lock QDs + Replacement O-Rings

If you’re looking for CM Becker OEM replacement parts, check out Keg Connection.  They have a nice diagram that shows all the parts and pieces – (gaskets, spring, stem and caps) for both ball lock and pin lock QDs.  See: Disconnect Parts List at Keg Connection

013 Silicone O-Ring, 70A Durometer, Red, 7/16″ ID, 9/16″ OD, 1/16″ Width (Pack of 100

Also: Kegerator Tips & Gear | Keg Repair Part #s | Recent Keg Finds

Our Top Draft Resources

This post contains affiliate links. We may make a commission when you use our Amazon links. This will never cost you extra. Thank you for supporting Homebrew Finds!

Make sure the components you use are compatible and rated for your intended application.  Contact manufacturer with questions about suitability or a specific application.  Always read and follow manufacturer directions.

prod:B000FMYQS0