Convert Chugger Center Inlet Pumps to Tri-Clamp

1.5" Tri Clover Compatible X 3/4" Female NPT

1/2″ fittings seem to be pretty standard for homebrewers.  Center inlet Chugger Pumps are a little different compared to most high temp homebrew pumps with regards to fittings.  Most homebrew pumps are 1/2″ NPT threads on both the “in” side and the “out” side.  The center inlet pump is 1/2″ NPT on the “out” side and 3/4″ NPT on the inlet side.  Some people want this to be 1/2″ also, so a fitting is required.

If you’re looking to convert your center inlet to tri-clamps Brewers Hardware has two fittings that make it easy.

Shop Around, Chugger Pumps

Related Review: Hands on Review: Chugger Pumps X-Dry Series Homebrew Pump!

More Tri-Clover/Tri-Clamp: Brewers Hardware has a gigantic selection of Tri-Clover Compatible Fittings including some really unique offerings  | Tri-Clamp Fittings at Proflow Dynamics

More: Our Last Fifty Finds!

Make sure the components you use are compatible and rated for your intended application.  Contact manufacturer with questions about suitability or a specific application.  Always read and follow manufacturer directions. rp:ccitotc

Leave a Reply